Start at the Catalog...

Sectional Doors

 

Operators

Loading Docks

Rolling Doors

Callout

Popular Manufacturers

X
Posted by | How To's | 0 |

program-3800

Using the Learn Button

Step 1: Press and release the purple “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.

Step 2: Within 30 seconds, press and hold the button on the hand-held remote* that you wish to operate your garage door.

Step 3: Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two click will be heard.

To add additional remote controls using the LCD control console

Step 1: Press the Prog <Learn> button on the LCD/Motion Detecting Control Console.

Step 2: Press the Prog <Learn> button again to confirm Learn Mode.

Step 3: Press the button on the hand-held remote that you wish to operate your garage door.

Step 4: When the motor unit lights blink, it has learned the code. If light bulbs are not installed, two clicks will be heard.

3-Button Remote Controls

If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any Security+ 3-Button remote or mini-remote can be programmed to operate other Security+ garage door openers.

To Erase All Codes From Motor Unit Assembly

To deactivate any unwanted remote, first erase all codes. To do this, press and hold the “learn” button on the motor unit until the learn indicator light goes out (approximately 6-9 seconds). All previous codes are now erased.

You can now reprogram each remote or keyless entry you wish to use.


Leave a Reply